Installation Instructions
Prerequisite:
Thoroughly clean the surface of dust, dirt or grease , before pasting anything . Do not use products containing nanoparticles or other
Put in a container of water possibly with soap and tip
Use this mixture to wet the surface
The regulars can ask dry .
It is possible to heat the vinyl to 120 ° to make it more malleable , remove bubbles ( vinyl is not waterproof air escapes naturally in a few days in the sun )
Sticker integrally :
Affix the sticker making sure it does not stick and soap and water are good role play more if wet .
Apply the entire sticker and hunt with a suitable spatula or a soft water and air bubbles from the center outward.
After 48 to 72 hours for a maximum time of the vinyl bonding the adhesive cohesion do with the support.
With this type of installation it is possible to operate the vehicle immediately after installation
Blow hot air (using a hair dryer or other ) to take vinyl curved shapes if necessary .
Stickers in one or more parts with film Application :
Remove film application ensuring that the vinyl comes well with the film. If this is not the case based the film and rub it with a fingernail or a stiff spatula and repeat the operation
Affix the sticker making sure it does not stick and soap and water are good role play more if wet .
Apply the entire sticker and hunt with a suitable spatula or a soft water and air bubbles from the center outward.
Removing the film ensuring that the lettering left on the support. If this is not the case, the water has not been removed .
After 48 to 72 hours for a maximum time of the vinyl bonding the adhesive to the carrier do cohesion
In some cases it may be difficult to remove the water of fairing too flexible enough support etc .... Just let it dry naturally and then a few hours to remove the film .
Condition arises that must be observed :
After washing the bike if you wipe the cloth should be clean and never served with any product of interviews
In all cases the installation must be protected from the sun , ideally in a closed and heated to 20° C
The air should not be wet
A temperature of 10 ° C and minimum essential.
In the case of a new painting it must be completely dry.
Maintenance condition :
The stickers should not be cleaned with corrosive because the colors and vinyl to a lesser extent are sensitive to chemicals.
Lance pressure washer must be maintained at a distance of 30 cm.
All our stickers can be varnished.